Table of Contents
Advertisement
Procedure
Step 1.
Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2.
Install a C1 rearwall bracket.
Note: The illustration shows removing a C1 rearwall bracket. The procedure is the same for
removing the C2 rearwall bracket.
Figure 147. C1 rearwall bracket installation
a.
Align the pin on the rearwall bracket and the pin slot on the right side of the rear chassis. Install
the bracket to the chassis as shown.
b.
Install the four screws to secure the rearwall bracket.
After you finish
1. Install a rear drive cage or riser assemblies. See
• "Install the 4 x 2.5-inch rear drive cage" on page 332
• "Install a PCIe adapter and riser 1/2 assembly" on page 350
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
319
Advertisement
Table of Contents
