Procedure
Step 1.
Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2.
Install an A1 rearwall bracket.
Figure 143. A1 rearwall bracket installation
a.
Align the pin on the rearwall bracket and the pin slot on the left side of the rear chassis. Install
the bracket to the chassis as shown.
b.
Install the three screws to secure the rearwall bracket.
After you finish
1. Install a rear drive cage or riser assemblies. See
• "Install the 4 x 2.5-inch rear drive cage" on page 332
• "Install the 8 x 2.5-inch rear drive cage" on page 336
• "Install the 2 x 3.5-inch rear drive cage" on page 323
• "Install the 4 x 3.5-inch rear drive cage" on page 327
• "Install a PCIe adapter and riser 1/2 assembly" on page 350
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
311