Procedure
Step 1.
Touch the static-protective package that contains the hot-swap power supply to any unpainted
surface on the outside of the server. Then, take the hot-swap power supply out of the package and
place it on a static-protective surface.
Step 2.
If there is a power-supply filler installed, remove it.
Figure 85. Hot-swap power supply filler removal
Step 3.
Slide the new hot-swap power supply into the bay until it snaps into position.
Figure 86. Hot-swap power supply installation
After you finish
1. Connect one end of the power cord to the new power supply connector; then, connect the other end of
the power cord into a properly grounded electrical outlet.
2. If you have adjusted the CMA to gain access to the power supply bay, properly readjust the CMA back
in place.
ThinkSystem SR665 Maintenance Manual
222