Procedure
Step 1.
If the server is installed in a rack, remove the server from the rack. See the Rack Installation Guide
that comes with the rail kit for your server.
Step 2.
Remove the top cover.
Attention: Handle the top cover carefully. Dropping the top cover with the cover latch open might
damage the cover latch.
Figure 187. Top cover removal
a.
Use a screwdriver to turn the cover lock to the unlocked position as shown.
b.
Press the release button on the cover latch and then fully open the cover latch.
c.
Slide the top cover to the rear until it is disengaged from the chassis. Then, lift the top cover off
the chassis and place the top cover on a flat clean surface.
.
Chapter 4
Hardware replacement procedures
393