Procedure
Step 1.
Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2.
Remove a C1 rearwall bracket.
Note: The illustration shows removing a C1 rearwall bracket. The procedure is the same for
removing the C2 rearwall bracket.
Figure 146. C1 rearwall bracket removal
a.
Remove the four screws.
b.
Remove the bracket from the chassis in the direction as shown.
After you finish
1. Remove or install a rear drive cage or riser assemblies. See
• "PCIe adapter and riser assembly replacement" on page 345
• "Rear drive cage replacement" on page 320
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
317