Procedure
Step 1.
Touch the static-protective package that contains the new riser card to ay unpainted surface on the
outside of the server. Then, take the new riser card out of the package ad place it on a static-
protective surface.
Step 2.
Install a B1 or B2 rearwall bracket.
Note: The illustration shows only the installation of B1 rearwall bracket, the B2 rearwall bracket
can be installed in the same way.
Figure 145. B1 rearwall bracket installation
a.
Align the holes on the rearwall bracket and the chasiss. Install the bracket to the chassis as
shown.
b.
Install the two screws to secure the rearwall bracket.
After you finish
1. Install a rear drive cage or riser assemblies. See
• "Install the 4 x 2.5-inch rear drive cage" on page 332
• "Install the 2 x 3.5-inch rear drive cage" on page 323
• "Install a PCIe adapter and riser 1/2 assembly" on page 350
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
315