Procedure
Step 1.
Touch the static-protective package that contains the new riser card to any unpainted surface on
the outside of the server. Then, take the new riser card out of the package and place it on a static-
protective surface.
Step 2.
Remove an A1 rearwall bracket.
Figure 142. A1 rearwall bracket installation
a.
Remove the three screws as shown.
b.
Remove the bracket from the chassis as shown.
After you finish
1. Remove or install a rear drive cage or riser assemblies. See
• "PCIe adapter and riser assembly replacement" on page 345
• "Rear drive cage replacement" on page 320
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
309