Procedure
Step 1.
Touch the static-protective package that contains the new intrusion switch to any unpainted
surface on the outside of the server. Then, take the new intrusion switch out of the package and
place them on a static-protective surface.
Step 2.
Connect the intrusion switch cable to the system board. See "System board components" on page
43.
Figure 91. Intrusion switch connection
Step 3.
Insert the intrusion switch into the intrusion switch bracket on the fan cage and push it in the
direction as shown until it is fully seated.
Note: Ensure that the intrusion switch cable is routed through the cable clip on the fan cage.
Figure 92. Intrusion switch installation
.
Chapter 4
Hardware replacement procedures
231