Cisco IE 3010 Hardware Installation Manual page 9

Product Overview
Cable Side
Table 2 SFP Modules Maximum Operating Temperature (continued)
Type of SFP Module
Extended temperature SFPs
23 to 185°F (-5°C to 85°C)
For minimum software requirements, refer to the Release Notes for your platform.
For the most up-to-date list of supported SFP models for Cisco Industrial Ethernet switches, see
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6981.html#wp1
38176
For information about SFP modules, see your SFP module documentation and the
page 35. For cable specifications, see the
SFP Module Patch Cable
The switch uses an SFP-module patch cable, a 0.5-meter, copper, passive cable with SFP module connectors at each
end (see Figure 3 on page
Figure 3 SFP-Module Patch Cable
See the Inserting and Removing the SFP Module Patch Cable, page 40
patch cable.
You can order this cable (part number CAB-SFP-50CM=).
Power-Input Terminal
The power-input terminal provides screw terminals for the AC and DC power connections. The switch can operate with
one or two power supplies. If one of the power sources fail, the other continues to power the switch. See
Installation, page 47
Model

SFP-GE-L with DOM support

SFP-GE-S with DOM support

SFP-GE-T

SFP-GE-Z with DOM support

GLC-LH-SMD with DOM support

GLC-EX-SMD with DOM support

GLC-TE

GLC-ZX-SMD with DOM support
SFP Module Cables, page
9). The patch cable connects two switches in a cascaded configuration.
for information.
Installing and Removing SFP Modules,
74.
for information about using the SFP module
9
Power Supply