Cisco IE 3010 Hardware Installation Manual page 14

Product Overview
Power-Supply Side
Dual-Purpose Port LEDs
The dual-purpose port LEDs identify the connection as either a copper-based connector or an SFP module. The ports
can autonegotiate, or you can manually configure each dual-purpose port as either 10/100/1000 with copper connectors
or as an SFP-module port, but not as both types at the same time. See
SD Flash Memory Card LED
Table 10 SD Flash Memory Card LED
Color
Off / blinking green
Blinking amber
Amber
Green
SD Flash Memory Card
The switch ships with the Secure Digital (SD) flash memory card installed. See
page 6. The switch stores the Cisco IOS software images and the switch configuration on the card. You should not
remove the card unless you want to use it in a replacement switch. You then do not have to reconfigure the new switch.
See the Replacing the SD Flash Memory Card, page 41
Power-Supply Side
The power-supply side has the LED panel and two power-supply slots for the removable power supplies. See
on page 14 and Figure 8 on page
Figure 7 Switch with One Power-Supply Module
C i sco
I E 301 0
Sw i t ch Ser
i es
1
2
1 LED panel
2 Power-supply slot 1
System Status
SD flash memory card transfer in progress.
SD flash memory card is not present (slow blinking).
Unsupported SD flash memory card is detected (fast blinking).
Error accessing the SD flash memory card.
Cisco IOS boot image cannot be found.
SD flash memory card is functioning.
for information.
15.
3
3 Power-supply slot 2
14
Table 8 on page 13 for LED descriptions.
Figure 1 on page 6 and Figure 2 on
Figure 7