Cisco IE 3010 Hardware Installation Manual page 56

Power Supply Installation
Power-Supply Module Installation
Figure 48 Connecting the Wires to the High-Voltage AC Power (PSU1)
DC Power Connection

Connect the positive wire into the terminal screw labeled "+", and the negative wire into the terminal screw labeled
"–".
Low-voltage DC Power-Supply Module

Connect the wires to the terminals labeled Lo.
High-voltage DC Power-Supply Module

Connect the wires to the terminals labeled Hi.
Note: Ensure that you cannot see any wire lead. Only wire with insulation should extend from the terminal screw.
Figure 49 Connecting the Wires to the Low-Voltage DC Power (PSU2)
C is c o IE C
is
c o
8. Torque the captive screws (above the wires) to 8.5 in-lb (± 0.5 in-lb).
9. Complete the power connection:
0 - 2 1 0
4 0
V ~ ,
5 0 -
H z , 6 0
2 . 2
A
1 0
0 - 2
V ~ , 4 0
5 0 -
6 0
2 . 2 H z ,
A
C C is c o IE 3 0 C is
c o
IE
3 0 1 3
1 0
0 0
IE
3 0 1 3 0 1 0
1
0 0
56