Cisco IE 3010 Hardware Installation Manual page 88

Configuring the Switch with the CLI Setup Program
Entering the Initial Configuration Information
You have completed the initial configuration of the switch, and the switch displays its configuration. This is an
example of the configuration output:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password enable_password
line vty 0 15
password terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
end
These choices appear:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
To save the configuration and use it the next time the switch reboots, select option 2 to save it in NVRAM.
Enter your selection [2]:2
9. Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. To change this
configuration or to perform other management tasks, enter commands at the
Switch>
88
prompt.