Cisco IE 3010 Hardware Installation Manual page 53

Hide thumbs Also See for IE 3010:

Power Supply Installation

Power-Supply Module Installation

Warning:

Only trained and qualified personnel should be allowed to install or replace this equipment.

Statement 1030

Warning:

Hazardous voltage or energy may be present on power terminals. Always replace cover when terminals

are not in service. Be sure uninsulated conductors are not accessible when cover is in place. Statement 1086

Ensure that the power is off at the AC or DC circuits.

Locate the circuit breakers, turn them OFF, and tape them in the OFF position.

Warning:

If the power is not off at the AC or DC circuit breaker, do not touch the power-input terminal.

Note:

Do not connect the switch to a power source that has an ON/OFF switch.

Use a Phillips screwdriver to loosen the captive screw on the power-input terminal, and open the cover.

Figure 44

Opening the Power-Input Terminal Cover

10 0- 24 0V

C is c o C G

S 2 5 2 0

The terminal screws labels are on the power-input terminal cover. See

~, 50 -6 0H

z, 2A

10 0- 24 0V

~, 50 -6 0H

z, 2A

10 A

Figure 45 on page

54.