Wiring The Power Source - Cisco IE 3010 Hardware Installation Manual

Power Supply Installation
Power-Supply Module Installation
Figure 41 Loosen the Screws on the Power Supply Blank
C i sco I E
301 0
Sw i t ch Ser
i es
Figure 42 Remove the Power Supply Blank
C i sco C onn
ect ed G ri
Sw i tch 250 d
0 Ser i es
3. Insert the power-supply module into the slot, and gently push it in. See
Note: Ensure that the power supply module is flush with the switch.
Figure 43 Insert the Power-Supply Module
4. Use a ratcheting torque screwdriver to torque each screw to 8–10 in-lb.

Wiring the Power Source

Before you wire the power source, review these warnings:
Warning: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:

AC: 5 A, DC: 15 A Statement 1005
Warning: A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Statement 1022
Figure 43 on page
52
52.