Table Of Contents - Cisco IE 3010 Hardware Installation Manual

Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your switch ships with at least
one installed power-supply module (AC or DC, depending on your order). The power-supply modules are
field-replaceable units (FRUs) and are hot-swappable.
For translations of the safety warnings in this chapter, see the Regulatory Compliance and Safety Information for the
Cisco IE 3010 Switch on the documentation CD and also on Cisco.com.

Power-Supply Modules, page 47

Installation Guidelines, page 49

Grounding the Switch, page 50

Installing the Power-Supply Module in the Switch, page 51

Wiring the Power Source, page 52

Removing the Power-Supply Module, page 57
Power-Supply Modules
For information on the power-supply modules, see
Table 12 Power-Supply Modules
Model
PWR-RGD-LOW-DC/IA
PWR-RGD-AC-DC/IA
Power Supply Features, page
Description
Low-voltage DC. For voltage information, see
High-voltage AC or DC. For voltage information, see
Cisco Systems, Inc.
Table 18 on page
www.cisco.com
47
16.
69.
Table 17 on page 69.