Cisco IE 3010 Hardware Installation Manual page 41

Switch Installation
Replacing the SD Flash Memory Card
Figure 29 Inserting an SFP Module Patch Cable
3. Repeat these steps for the second switch that you want to connect to the first switch.
Figure 30 Connecting Two Switches with an SFP Module Patch Cable
Removing the SFP Module Patch Cable
To remove an SFP module patch cable from the SFP module slot, release the connector, and pull it from the slot.
Replacing the SD Flash Memory Card
1. Locate the SD flash memory card slot on the cable-side of the switch.
2. Use a number-1 Phillips screwdriver to loosen the captive screw. See
PO W ER
O VER ET H ER N
ET
PO W ER
O VER
ET H ER N
ET
C i sc o IE
30 10
PO W ER
O VER
ET H ER N
ET
PO W ER
O VER
ET H ER N
ET
C i sc o IE
30 10
C i s c o IE
3 0 1 0
Figure 31 on page
41
42.