Configuring the Switch with the CLI Setup Program
Accessing the CLI Through the Console Port
Figure 64
Connecting the Console Cable
2
1
RJ-45 console port
3.
Configure the baud rate and character format of the PC or terminal to match the console port characteristics:
—
9600 baud
—
8 data bits
—
1 stop bit
—
No parity
—
None (flow control)
4.
Connect power to the switch as described in
5.
The PC or terminal displays the bootloader sequence. Press Enter to display the setup prompt. Follow the steps in
the
Completing the Setup Program, page
USB Console Port
1.
If you are connecting the switch USB console port to a Windows-based PC for the first time, install a USB driver. See
Figure 65 on page
Installing the Cisco Microsoft Windows XP USB Driver, page 84
Installing the Cisco Microsoft Windows 2000 USB Driver, page 84
1
C i sco IE
301 0
1
2
Console cable (RJ-45-to-DB-9 adapter
cable)
86.
83.
Power Supply Installation, page 47
82