Cisco IE 3010 Hardware Installation Manual page 55

Power Supply Installation
Power-Supply Module Installation
You can also use a ring or flanged spade terminal as listed in the
Figure 47 Crimping the Spade Terminal Lug
6. Loosen the terminal screw, and slide the terminal under the screw and washer. See
Note: Use the appropriate terminal screws based on power supply type: high-voltage (AC or DC) or low-voltage
(DC).
7. Make the power connection:
AC Power Connection

Connect the line wire into the terminal screw labeled L and the neutral wire into the terminal screw labeled N to
complete the AC connection.
Equipment That You Need, page
55
49.
Figure 49 on page 56.