Preparing The Machine; Disconnecting The Spark-Plug Wire; Disconnecting The Battery - Toro 04063 Installation Instructions Manual

1

Preparing the Machine

No Parts Required
Disconnecting the Spark-Plug
Wire
800, 1000, and 1600 Series Machines
1. Ensure that the reel-drive lever is in the
D position; refer to the Operator's
ISENGAGE
Manual.
2. Move the machine to a level surface and set
the traction-drive lever to the N
refer to the Operator's Manual.
3. Set the throttle control to the S
push the On-Off switch to the O
to the Operator's Manual.
4. Engage the service brake and hold in place with
the parking-brake knob; refer to the Operator's
Manual.
5. Remove the spark-plug wire from the terminal of
the spark plug (Figure
1. Spark-plug wire
Disconnecting the Spark-Plug
Wire
Flex 1820 and 2120 Series Machines
1. Ensure the traction and reel drive engagement
lever is in the D
ISENGAGE
Operator's Manual.
position;
EUTRAL
position and
LOW
position; refer
FF
1).
Figure 1
position; refer to the
2. Move the machine to a level surface and set
the traction and reel drive engagement lever to
the N
EUTRAL
Manual.
3. Set the throttle control to the S
push the On-Off switch to the O
to the Operator's Manual.
4. Pull the service brake lever back and hold in
place with the parking-brake latch; refer to the
Operator's Manual.
5. Remove the spark-plug wire from the terminal of
the spark plug

Disconnecting the Battery

eFlex 1820 and 2120 Series Machines
1. Ensure the traction and reel drive engagement
lever is in the D
Operator's Manual.
2. Move the machine to a level surface and set
the traction and reel drive engagement lever to
the N
EUTRAL
Manual.
3. Rotate the key switch to the O
to the Operator's Manual.
4. Pull the service brake lever back and hold in
place with the parking brake latch; refer to the
Operator's Manual
5. Wait 10 to 15 minutes for the motor capacitors
to discharge.
6. Disconnect the T-handle connector of the battery
adapter wire harness from the P04 connector of
the battery wire harness
g032966
1. P04 T-handle connector
(battery adapter wire
harness)
2
position; refer to the Operator's
position and
LOW
position; refer
FF
(Figure 1).
position; refer to the
ISENGAGE
position; refer to the Operator's
position; refer
FF
(Figure 2).
Figure 2
2. P04 connector (battery
wire harness)
g210482