Advertisement
Figure 5
1. Bolt—loosen
3. Use 4 flange-head bolts (3/8 inch) and 2 flange
nuts (3/8 inch) to secure the light mounts to both
side plates
(Figure
Note:
Ensue that the throttle cable is routed
behind the light mount.
Figure 6
1. Flange-head bolt (3/8
inch)
2. Light mount
4. Remove the nut and the washer from each LED
light assembly, then use the nut and the washer
to secure the LED lights to each light mount
(Figure
7).
6).
3. Flange nut (3/8 inch)
g207878
1. LED light
2. Light mount
4
Assembling the Light
Mounts to the 1820 or 2120
Series Machine
Parts needed for this procedure:
2
LED light assembly
2
Light mount
1
Mount plate
1
Flange-head bolt (3/8 inch)
g206126
1
Flange-head bolt (5/16 x 1 inch)
4
Flange-head bolt (5/16 x 1-1/2 inches)
4
Flange locknut (5/16 inch)
1
Flange nut (3/8 inch)
1
Flange nut (5/16 inch)
4
Washer
Procedure
1. Use 2 flange-head bolts (5/16 x 1-1/2 inches), 2
washers, and 2 flange nuts (5/16 inch) to secure
the mount plate to the left side plate
or
Figure
4
Figure 7
3. Washer
4. Nut
9).
g200656
(Figure 8
Advertisement
