2
Removing the
Control-Panel Cover
1820 or 2120 Series Machines
No Parts Required
Procedure
1. Remove the 4 flange-head screws (1/4 x 1/2
inch) that secure the control-panel cover to the
support bracket of the handle bar
1. Control-panel cover
2. Flange-head screw (1/4 x
1/2 inch)
2. Move the control panel cover up and forward
from the control panel, and remove the cover
from the machine
Note:
Retain the flange-head screws and
control-panel cover for assembly in
Control-Panel Cover (page
(Figure
Figure 3
3. Support bracket (handle
bar)
(Figure
3).
Installing the
14).
3
Assembling the Light
Mounts to the 800, 1000,
and 1600 Series Machine
Parts needed for this procedure:
2
LED light assembly
2
Light mount
4
Flange-head bolt (3/8 inch)
2
Flange nut (3/8 inch)
3).
Procedure
1. Remove and discard the bolt from the upper
frame of both side plates as shown in
g032757
1. Bolt
2. Loosen the bolts on the right reel drive cover,
then raise the cover
Important:
bolts.
Note:
wrench to tighten the bolt that is closest to the
cover.
3
Figure 4
(Figure
5).
Loosen, but do not remove the
Raising the cover will allow you to use a
Figure
4.
g210479