Advertisement
Quick Links
Out-Front Brush Kit
Greensmaster
1800/2100 Mower
Model No. 04266
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Left brush bracket
Right brush bracket
Flange head bolt (3/8 x 1 inch)
Bolt (M10 x 30 mm)
Level adjustment screw
Jam nut (5/16 inch)
Lock nut (5/16 inch)
Brush spring
Brush rod
Bolt (M6 x 40 mm)
Spacer
Locknut (M6)
Left brush bracket
Right brush bracket
Bolts (fully threaded, 5/16 x 1-1/2 inches)
Locknut (5/16 inch)
Level adjustment screw
Jam nut (5/16 inch)
Lock nut (5/16 inch)
Brush spring
Brush rod
Bolt (M6 x 40 mm)
Spacer
Locknut (M6)
Brush
Brush tab
Bolt (M8 x 60 mm)
Washer
Locknut (M8)
Flange-head bolt (M6 x 20 mm)
Flange nut (M6)
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
800/1000/Flex
Qty.
1
1
2
2
2
2
Mount the brush brackets (Greensmaster Flex models
only)
2
2
2
4
4
4
1
1
4
4
2
2
Mount the brush brackets (Greensmaster 800/1000/2000
models only)
2
2
2
4
4
4
1
2
4
4
Mount the brush.
4
4
4
Register at www.Toro.com.
™
18/21/Flex
™
1800/2100/eFlex
Installation Instructions
Use
Original Instructions (EN)
All Rights Reserved *3427-206* A
Printed in the USA
Form No. 3427-206 Rev A
®
Advertisement
Related Manuals for Toro 04266
Summary of Contents for Toro 04266
- Page 1 Greensmaster ® 800/1000/Flex ™ 18/21/Flex ™ 1800/2100/eFlex ® 1800/2100 Mower Model No. 04266 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Left brush bracket Right brush bracket Flange head bolt (3/8 x 1 inch)
- Page 2 Mounting the Brush Brackets Greensmaster Flex Models only Position the machine on a level surface, engage the parking brake, remove the key (if equipped), disconnect the battery, and shut off the machine. Remove the bolt and washer securing the left end of the front frame to the tab on top of the cutting unit (Figure...
- Page 3 g017161 Figure 3 1. Locknut (M6) 4. Brush spring g017162 Figure 4 2. Brush rod 5. Bolt (M6 x 40 mm) 3. Spacer 1. Bolt 3. Grass basket mounting 2. Washer Repeat this procedure on the opposite side of the machine. Secure the grass basket mounting rod to the left Note: There will be leftover locknuts.
- Page 4 Loosely mount the level adjustment screw to the brush bracket with a jam nut (5/16 inch) and a locknut (5/16 inch) as shown in Figure Mount a brush spring and brush rod to the brush bracket with 2 bolts (M6 x 40 mm), spacers, and locknuts (M6) as shown in Figure Note:...