Advertisement
Figure 28
Left side of the machine shown
1. Wire harness (machine)
2. Cable tie
•
eFlex/Flex 1820 and 2120 Series
machines:
Use a cable tie to bundle the remaining
length of the wire harness together
29).
Note:
Perform this step for both sides of the
machine.
Figure 29
Left side of the machine shown
1. Installed 2-pin connector
(wire harness—LED light
kit)
g032885
3. Wire harness (LED light
kit)
(Figure
g200973
2. Cable tie
8
Finishing the Light Kit
Installation
No Parts Required
Installing the Control-Panel Cover
1820 or 2120 Series Machines
1. Align the keyhole slot in the control-panel cover
over the traction and reel drive handle
30).
1. Traction and reel drive
handle
2. Keyhole slot (control-panel
cover)
2. Align the holes in the control-panel cover to the
holes in the support bracket of the handle bar
(Figure
30).
3. Assemble the cover to the bracket
30) with the 4 flange-head screws (1/4 x 1/2
inch) that you removed in
Control-Panel Cover (page
14
(Figure
Figure 30
3. Flange-head screw (1/4 x
1/2 inch)
4. Support bracket (handle
bar)
(Figure
2 Removing the
3).
g032818
Advertisement
