Toro 04063 Installation Instructions Manual page 12

Installing the Light Switch
(eFlex/Flex 1820 and 2120 Series
Machines)
1. Remove the plug from the opening at the left
face of the control panel
Figure 24
eFlex 1820/2120 Machine Shown
1. Plug
2. Opening (control panel)
(Figure 24 or Figure 25).
g032849
3. 2-position rocker switch
4. 8-socket connector (wire
harness—LED light and
wireless hour meter
harness kit)
Flex 1820/2120 Machine Shown
1. Plug
2. Opening (control panel)
2. Pull up the 8-socket connector of the wire
harness for the machine through the opening in
the control panel
3. Connect the 8-pin connector of the 2-position
rocker switch into the 8-socket connector of
the wire harness for the machine
Figure 25).
Ensure that the connectors are fully seated
and the latch of the connectors snap together
securely.
4. Align the switch so that the notch in the body
of the switch is toward the back of the control
panel (Figure
12
Figure 25
3. 2-position rocker switch
4. 8-socket connector (wire
harness—LED light and
wireless hour meter
harness kit)
(Figure 24 or Figure
(Figure 24
26).
g208352
25).
or