Advertisement
Connecting the LED Light Wire
Harnesses to the Machine Wire
Harness
Flex 1820 and 2120 Series Machines
Note:
Perform the following steps for the LED light
wire harnesses on both sides of the machine.
1. At the front of the console, remove the plug
from the 2-socket connector of the machine wire
harness
(Figure
18).
Figure 18
Left side of the machine shown
1. 2-pin connector (wire
harness—LED light kit)
2. Plug
2. Connect the 2-pin connector of the LED light
wire harness to the 2-socket connector of the
machine wire harness
Ensure that the connectors are fully seated
and the latch of the connectors snap together
securely.
3. Perform the previous steps for the wire harness
on the other side of the machine
g210534
3. 2-socket connector (wire
harness—machine)
(Figure
18).
(Figure
19).
1. Installed 2-pin connector (wire harness—LED light kit)
9
Figure 19
g210792
Advertisement
