Advertisement
5
Assembling the Wire
Harnesses to the Machine
Parts needed for this procedure:
2
Wire harness
Attaching the Wire Harnesses to
the LED Lights
1. Connect the 2-pin connector of the LED light into
the 2-socket connector of the LED light harness
(Figure
13).
Ensure that the connectors are fully seated
and the latch of the connectors snap together
securely.
Figure 13
1. 2-socket connector (wire
harness)
2. Repeat step
1
for the other wire harness and
LED light.
Routing the Wire Harness
Route the wire harnesses down each light mount and
up each handle as shown in
Note:
Ensure that the wire harnesses are routed
below the differential axle shaft
g200657
2. 2-pin connector (LED light)
Figure
14.
(Figure
15).
800, 1000, and 1600 Series Machine shown
1. Wire harness
800, 1000, and 1600 Series Machine shown
1. Wire harness
7
Figure 14
Figure 15
2. Differential axle shaft
g210745
g210746
Advertisement
