Table of Contents
Advertisement
2.
Push OFF button (see Figure 21).
OFF Button
Power Lamp
Figure 21. Control panel components.
3.
Connect machine to power source. Power
lamp will illuminate (see Figure 21).
4.
Twist OFF button clockwise until it pops
out (see Figure 22). This resets button so
machine will start.
OFF Button
Figure 22. Resetting the OFF button.
5.
Push ON button to turn machine ON. A cor-
rectly operating machine will run smoothly
with little or no vibration or rubbing noises.
6.
Press OFF button to turn machine OFF.
7.
WITHOUT resetting OFF button, press ON
button. Machine should not start.
— If machine does not start, the OFF
button
safety
correctly. Congratulations! The Test Run is
complete.
— If
machine
does
button pushed in), immediately disconnect
power to machine. The OFF button safety
feature is not working correctly. This safety
feature
must
proceeding with regular operations. Call
Tech Support for help.
Model G0834 (Mfd. Since 12/17)
ON Button
feature
is
working
start
(with
OFF
work
properly
before
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Factory adjustments that should be verified:
•
Outfeed Table Height (refer to Page 37).
•
Depth Scale Calibration (refer to Page 38).
Table Parallelism (refer to Page 39).
•
•
Fence Stop Accuracy (refer to Page 43).
Tightening Belts
The final step in the setup process must be done
after approximately 16 hours of operation. During
this first 16 hours, the belt will stretch and seat
into the pulley grooves. After this time, you must
re-tension the belt to avoid slippage and burn out.
Refer to Page 35 when you are ready to perform
this important adjustment.
Note: Pulleys and belt can get hot. This is a
normal condition. Allow them to cool before
making adjustments.
A small amount of black belt dust at the bottom
of the belt housing is normal during the life of the
machine and does not indicate a problem with the
machine or belt.
-21-
Advertisement
Table of Contents
