Inventory - Grizzly G0834 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figures 8–10)
A. Jointer ......................................................... 1
B. Control Panel Pedestal Assembly .............. 1
C. Fence Assembly ......................................... 1
D. Cutterhead Guard ....................................... 1
E. Push Blocks ................................................ 2
F.
Hardware Bag (Not Shown)
• Cap Screws M10-1.5 x 30 (Pedestal)...... 4
• Lock Washers 10mm (Pedestal) ............. 4
• Flat Washers 10mm (Pedestal) .............. 4
• Lock Nut M12-1.75 (Fence) ..................... 1
• Flat Washer 12mm (Fence) .................... 1
• Open-End Wrench 12/14mm .................. 1
• Open-End Wrench 17/19mm .................. 1
• Hex Wrenches 3, 4, 5, 8mm .......... 1 Each
• Torx Driver Bit T20 .................................. 2
• Torx L-Wrench T20 ................................. 2
• Flat Head Torx Screws T20 M6-1 x 15 ... 3
• Carbide Inserts 15 x 15 x 2.5mm ............ 5
A
Figure 8. Jointer assembly.
-14-
Figure 9. Control panel pedestal assembly.
Qty
C
E
Figure 10. Additional crate contents.
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
B
NOTICE
Model G0834 (Mfd. Since 12/17)
D