Recommended Adjustments - Grizzly G0958 Owner's Manual

4. Remove ON/OFF switch disabling key, as
shown in Figure 14.
Figure 14. Removing key from paddle switch to
disable switch and prevent unauthorized use.
5.
Try to start machine.
— If machine does not start, switch disabling
feature is working as designed. Proceed to
Step 6.
— If machine starts, immediately turn
machine OFF and disconnect from power.
Switch disabling feature is not working
correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
6. Re-install disabling key in ON/OFF switch.
7. Remove dust port housing.
8. Try to start machine.
— If machine does not start, interlock switch
disabling feature is working as designed.
Congratulations, test run is now complete!
— If machine starts, immediately turn machine
OFF and disconnect from power. Interlock
switch disabling feature is not working
correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
-24-
Recommended
Adjustments
The adjustments listed below have been per-
formed at the factory. However, because of the
many variables involved with shipping, we recom-
mend that you verify the adjustments to ensure
the best possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in the SERVICE section starting on
Page 43.
Factory adjustments that should be verified:
• Tensioning/replacing V-belts (Page 46).
• Calibrating jointer depth-of-cut scale (Page 48).
Calibrating planer thickness scale (Page 48).
•
After approximately 16 hours of operation,
motor V-belt will stretch and seat into pulley
grooves and need to be properly tensioned
to avoid severely reducing life of V-belt.
Refer to Tensioning/Replacing V-Belts on
Page 46 for detailed instructions.
Model G0958/G0959 (Mfd. Since 05/22)