Setting Outfeed Table Height - Grizzly G0834 Owner's Manual

4. Loosen hex nuts on motor tension rods
(see Figure 43).
Tension Rods
w/Hex Nuts
Motor Mount
Fastener (1 of 4)
Figure 43. Location of motor tension rods, hex
nuts, and motor mount fasteners.
5.
Loosen motor
Figure 43).
6.
Position motor as needed to align motor
pulley with cutterhead pulley.
7.
Tighten motor mount fasteners. V-belts
should be parallel and aligned, as illustrated
in Figure 42 on Page 36.
8.
Press down on motor until there is proper
tension on V-belts. While holding motor
down, tighten hex nuts on tension rods
(see Figure 43).
9. Check belt tension (refer to Step 3
of Tensioning V-Belts on Page 35 for
instructions).
10. Replace rear access motor cover and close
cutterhead pulley cover.
Model G0834 (Mfd. Since 12/17)
mount fasteners (see
Setting Outfeed
Table Height
The outfeed table height must be even with the
top of the cutterhead knives when they are posi-
tioned at top dead center. If the outfeed table is
set too low, there will be snipe. If the outfeed table
is set too high, the workpiece will hit the edge of
the outfeed table during operation, increasing the
chance of kickback.
Items Needed
Open-End Wrench 17mm .................................. 1
Precision Straightedge ...................................... 1
To set outfeed table height:
1. DISCONNECT MACHINE FROM POWER!
2. Remove cutterhead
assembly.
3. Loosen outfeed table lock and positive stop
bolt jam nut (see Figure 44).
Positive Stop Bolt
Figure 44. Location of outfeed table lock,
positive stop bolt, and jam nut.
Qty
guard and fence
Outfeed Table Lock
Jam Nut
-37-