Calibrating Depth-Of-Cut Scale - Grizzly G0834 Owner's Manual

4. Open cutterhead pulley cover and rotate
cutterhead pulley until one cutterhead insert
is at top dead center (its highest point during
rotation), as shown in Figure 45.
Top Dead
Center
Figure 45. Cutterhead insert at top dead center.
5.
Place straightedge over center of outfeed
table so it hangs over cutterhead.
When correctly set, cutterhead insert will
barely touch straightedge when cutterhead
is rotated back and forth with pulley, as
shown in Figure 46. Bottom Dead
Center
— If your outfeed table is correctly set, no
adjustments are necessary.
— If cutterhead insert lifts straightedge off
the table or it is below straightedge, then
outfeed table height must be reset.
Straightedge
Outfeed
Figure 46. Using straightedge to check outfeed
table height.
6. Use outfeed table adjustment handwheel to
set outfeed table height so cutterhead insert
barely touches straightedge, as shown in
Figure 46.
7. Tighten outfeed table lock, and tighten
outfeed positive stop bolt and jam nut so
outfeed table will not move during operation.
8. Re-install cutterhead guard and fence
assembly, and close cutterhead pulley cover.
-38-
Depth-of-Cut Scale
The depth scale can be calibrated or "zeroed" to
make sure the cutting depth shown on the scale
matches the actual cutting depth (per pass).
To calibrate the depth scale:
Items Needed
Phillips Screwdriver #2 ...................................... 1
1.
Set the outfeed table height as described in
Precision Straightedge ...................................... 1
Setting Outfeed Table Height.
To calibrate depth-of-cut scale:
2.
Place a straightedge across the infeed and
outfeed tables.
1.
DISCONNECT MACHINE FROM POWER!
3.
Adjust the infeed table until it is level with the
2. Perform Setting Outfeed Table Height on
outfeed table, as shown below.
Page 37.
4.
Using a screwdriver, precisely adjust the
3.
Place a straightedge across infeed and
scale pointer to "0".
outfeed tables.
4.
Adjust infeed table until even with outfeed
table, as shown in Figure 47.
Outfeed
Infeed
Figure 47. Infeed table even with outfeed table.
5.
Precisely adjust scale pointer to "0", as
shown in Figure 48.
Figure 48. Adjusting scale pointer to " 0 ".
Calibrating
Straightedge
Scale
Pointer
Model G0834 (Mfd. Since 12/17)
Qty
Infeed