Grizzly G0834 Owner's Manual page 44

7. Place straightedge in each position shown
in Figure 58, and adjust eccentric bush-
ings under outfeed table so straightedge
touches cutterhead body while lying flat
across outfeed table.
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 58. Straightedge positions for verifying if
outfeed table is parallel with cutterhead.
8. Repeat Step 7 as many times as necessary
until outfeed table is parallel with cutterhead.
9. Tighten set screws on each eccentric
bushing on outfeed table.
10. Place straightedge halfway across infeed and
outfeed table, and adjust infeed table even
with outfeed table, as shown in Figure 59.
Straightedge
Outfeed Table
Figure 59. Infeed and outfeed tables set evenly.
-42-
11. Place straightedge in each position shown
Black Lines Represent
Straightedge Positions
from Overhead View
Figure 60. Straightedge positions for checking
12. Repeat Step 10 as many times as necessary
13. Tighten set screws on each eccentric
14. Re-install front and rear table covers, table
15. Perform Setting Outfeed Table Height on
Infeed Table
in Figure 60, and adjust eccentric bushings
under infeed table so straightedge lies flat
against both tables.
infeed/outfeed table parallelism.
until infeed table is parallel with outfeed table.
bushing on infeed table.
locks, and cutterhead lock, and close
cutterhead pulley cover.
Page 37.
Model G0834 (Mfd. Since 12/17)