Grizzly G0834 Owner's Manual page 7

Figure 3. Location of depth-of-cut scale
indicator.
K. Depth-of-Cut Scale: Indicates depth of cut
(per pass).
M
Figure 4. Location of positive stops bolts.
L. Infeed Positive Stop Bolt: Allows operator
to quickly adjust the infeed table to perform
heavy or light cuts. It controls the bottom
range of infeed table movement. A jam nut
locks the positive stop bolt in position so it will
not move during operation.
M. Outfeed Positive Stop Bolt: Adjusts the
outfeed table height. It controls the bottom
range of outfeed table movement. A jam nut
locks the positive stop bolt in position so it will
not move during operation.
Model G0834 (Mfd. Since 12/17)
K
L
Fence Controls
P
Figure 5. Location of fence controls.
N. Fence Tilt Handle: Tilts fence throughout
its range of motion from 45° inward to 45°
outward (135°).
O. Fence Lock Lever: Tightens to secure fence
position along width of tables; loosens to
allow lateral adjustment.
P. Fence Tilt Lock: Secures fence at any
position in available tilt range.
Q
S
Figure 6. Location of fence tilt locks.
Q. 90° Fence Tilt Stop: Stops fence at 90°.
R. 45° Outward Fence Tilt Stops: Stop fence
at 45° outward (135°).
S. 45° Inward Fence Tilt Stop: Stops fence at
45° inward.
Note: Even when fence is resting against
stops, fence tilt lock must be tightened before
starting machine.
N
O
R
-5-