Ssb Radiotelephone; Transmitting; Choosing Class Of Emission - Furuno FS-1570 Operator's Manual

2

SSB RADIOTELEPHONE

You can enter desired frequency by channel or TX and RX frequencies. The handset may
be ON HOOK or OFF HOOK.
Note: To set the SSB radiotelephone to 2182 kHz/J3E, press the [1/ RT/2182] key more
than two seconds.

2.1 Transmitting

After selecting class of emission and frequency, you can transmit by pressing the PTT
switch on the handset. Output power is shown on the display.

2.1.1 Choosing class of emission

1. At the radiotelephone screen, choose class of emission (mode) as follows:
Rotate the [ENTER] knob to choose MODE and then push the [ENTER] knob.
SSB
MODE: SSB
CH: 800
TLX
AM
TX: 2182.0
RX: 2182.00
AGC : FAST
SEN
VOL
b) Rotate the [ENTER] knob to choose mode desired and then push the [ENTER] knob.
SSB: Single Sideband, TLX: Telex, AM: AM.
2. AGC is automatically selected according to mode. AGC FAST: SSB, AGC OFF: TLX,
AGC SLOW: AM. However, you may change it as below.
a) Rotate the [ENTER] knob to choose AGC and then push the [ENTER] knob.
MODE: SSB
CH: 200
TX: 2182.0
RX: 2182.00
OFF
FAST
AGC : FAST
SLOW
FAST
SEN
FAST
VOL
b) Rotate the [ENTER] knob to choose OFF, SLOW or FAST as appropriate and then push
the [ENTER] knob.
Note: You cannot transmit on the AM mode.
SIMP HIGH
KHZ
KHZ
S
IA 0.0A
SIMP HIGH
KHZ
KHZ
S
IA 0.0A
2-1