Manual Entry Of Position And Time - Furuno FS-1570 Operator's Manual

1.8 Manual Entry of Position and Time

If there is no EPFS (Electronic Position-Fixing System) connected to this equipment or the
EPFS connected is not working (EPFS error indication appears), manually enter position
and time as follows:
1. At the DSC standby screen, press the [#/SETUP] key to display the Setup menu.
Setup menu
****
ALARM
AUTO ACK
ERASE
MESSAGE
POSITION
PRINT OUT
2. Rotate the [ENTER] knob to choose POSITION and then push the [ENTER] knob.
Position setup
**
INPUT TYPE: AUTO
°
LAT : 34 41 NORTH
°
LON : 135 30 EAST
TIME: 09: 00 UTC
3. Push the [ENTER] knob to open the INPUT TYPE menu.
Position setup
**
INPUT TYPE: AUTO
AUTO
°
LAT : 34 41 NORTH
N
MANUAL
°
LON : 135 30 EAST
TIME: 09: 00 UTC
Note 1: If, when INPUT TYPE is AUTO, input from the navigator is interrupted, the
message "EPFS error!" appears. If this occurs, check the navigator.
Note 2: When INPUT TYPE is MANUAL, the message "Warning: Update position"
appears at set intervals (POSITION OLDER on the Alarm menu) to ask you to
update position.
4. Rotate the [ENTER] knob to choose MANUAL and then push the [ENTER] knob.
****
SCAN FREQ
VOLUME
TEST
SYSTEM
**
**
1 OPERATIONAL OVERVIEW
1-5