Maintenance & Troubleshooting; Daily Test - Furuno FS-1570 Operator's Manual

12 MAINTENANCE &
TROUBLESHOOTING

12.1 Daily Test

Authorities require that the DSC/watch receiver be checked daily for proper operation to
ensure that it will function properly in the event of distress. Execute the daily test as below.
1. At the DSC standby screen, press the [3/TEST] key to start the test.
2. After several seconds the test results, OK, for normal operation, NG for No Good,
appear followed by the audio alarm. For NG (No Good) contact your dealer for advice.
Daily test
**
MAR-27-2002-15:24
MAIN CPU : OK VER. XX*
PANEL1 : OK VER. XX*
PANEL2*1 : OK VER. XX*
MODEM : OK
NBDP MODEM : OK
Page 1
3. After the test results for the items on page 2 appear, the ALARM lamp flashes three
times and then
page 1 of the daily
test is displayed.
4. If auto printing is
active, the test
results are printed.
To manually print
the test results,
press the
[8/PRINT] key. At
right is a sample
test results printout.
5. Press the [CANCEL] key to quit the test and return to the previously used screen.
WARNING
Do not open the equipment.
Hazardous voltage which can
cause electrical shock exists
inside the equipment. Only
qualified personnel should
work inside the equipment.
** **
RCVR1
RCVR2*1
TRX
Test results
* DAILY TEST
MAR-27-2002-15:24:00
MMSI: 123456789
MAIN CPU: OK VER.XX*
PANEL1: OK VER.XX*
PANEL2:** OK VER.XX*
MODEM: OK VER.XX*
NBDP MODEM:OK VER.XX*
RCVR1: OK
RCVR2:** OK
TRX: OK
Daily test
**
: OK
: OK
: OK
Page 2
*
XX*= Version No.
** = PANEL2, RCVR2 printed
if equipped with no. 2
control unit.
XX* = Version No.
*1 = If equipped with No. 2 control unit.
12-1