Usb Port - NETGEAR M4300 Intelligent Edge Series Hardware Installation Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
• Gigabit transceiver modules:
- AGM734. SFP transceiver 1000BASE-T, SFP copper RJ-45 GBIC
- AXM765. SFP+ transceiver 10GBASE-T, SFP+ copper RJ-45 GBIC
Note: The AXM765 module is supported on switch models M4300-24XF and
M4300-48XF only.
• Direct attach cables:
- AXC761. SFP+ 1m direct attach cable
- AXC763. SFP+ 3m direct attach cable
- AXC765. SFP+ 5m direct attach cable
- AXC767. SFP+ 7m direct attach cable
- AXC7610. SFP+ 10m direct attach cable
- AXC7615. SFP+ 15m direct attach cable
- AXC7620. SFP+ 20m direct attach cable
For more information about NETGEAR SFP and SFP+ transceiver modules and cables,
visit netgear.com/business/products/switches/modules-accessories. If purchased,
transceiver modules and cables are shipped separately form the switch.

USB port

The switch provides one USB 2.0 port that lets you upgrade firmware from a disk, back
up the configuration to a storage device, and allow for the collection of a memory dump
for debugging purposes.
A device that you attach to the USB port must comply with the following requirements:
• The USB device must support USB 2.0.
• The USB device must support the FAT32 or VFAT file type. The NTFS file type is not
supported.
Because of hardware limitations, the write speed to and read speed from a USB device
is about 1 Mbps.
Note: In a stack, only the switch that functions as the master can detect and manage
an attached USB device.
Hardware Overview 42 Hardware Installation Guide