Leds, M4300 Series 1G Models With 10G Uplinks - NETGEAR M4300 Intelligent Edge Series Hardware Installation Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches

LEDs, M4300 series 1G models with 10G uplinks

This section describes the LED designations of the 1G models with 10G uplinks.
Table 2. LEDs of the 1G models with 10G uplinks
LED
Stack ID LED
Power 1 LED (for PSU 1)
and
Power 2 LED (for PSU 2)
Fan LED
Stack Master LED
Non-PoE models
1000BASE-T RJ-45 port
LEDs
(two LEDs per ports)
Hardware Overview
Description
Stack ID. The Stack LED contains segments that can indicate the stack unit number
of the switch:
Solid green indicating a number. The switch is a member of a stack. The LED
displays the stack unit number.
Solid green indicating E. The switch functions in ECO mode with all port LEDs
turned off.
Off. The switch is not a member of a stack.
Solid green. The power module is present, is supplying power to the switch, and
is functioning normally.
Solid yellow. The switch is booting.
Blinking yellow. The system boot-up failed or another failure occurred.
Off. Power is not supplied to the switch. The fans are off.
Solid green. The fans are functioning normally.
Blinking yellow. One or more fans failed.
Off. Power is not supplied to the switch.
Solid green. The fans are functioning normally.
Solid yellow. One or more fans failed.
Off. Power is not supplied to the switch.
Solid green. The switch is functioning as a master in a stack.
Off. The switch is not a member of a stack or is functioning as a slave in a stack.
Non-PoE models, left side speed LED:
Off. No link is established on the copper port.
Solid green. The copper port established a 1000 Mbps link.
Solid yellow. The copper port established a 10 or 100 Mbps link.
Non-PoE models, right side activity/link LED:
Off. No link is established on the copper port.
Solid green. The copper port established a link.
Blinking green. The copper port is transmitting or receiving packets.
29 Hardware Installation Guide