NETGEAR M4300 Intelligent Edge Series Hardware Installation Manual page 9

M4300 Intelligent Edge Series Fully Managed Stackable Switches
- Full 10G models with combo ports:
- Twenty or forty-four independent 10GBASE-T autosensing ports and four 10G
RJ45/SFP+ combo ports
-
Twenty-two or forty-six independent 10G fiber ports and two 10G RJ45/SFP+
combo ports
• Support from 128G to 960G switching fabric (all ports line-rate), depending on the
model.
• One out-of-band 1G Ethernet port.
• One RJ-45 RS232 console port.
• One mini USB console port.
• One regular USB port for connection to a storage device.
• One or two power supply unit (PSU) bays for small form-factor modular PSUs. For
the dual PSU bay models, the second PSU can support 1+1 redundancy.
• Support for stacking on any 10G port.
• Half-width or full-width model.
• Full compatibility with IEEE standards:
- IEEE 802.3i (10BASE-T)
- IEEE 802.3u (100BASE-TX)
- IEEE 802.3ab (1000BASE-T)
- IEEE 802.3an (10GBASE-T)
- IEEE 802.3z (1000BASE-X)
- IEEE 802.3 Clause 49 (10GBASE-LR and 10GBASE-SR)
- IEEE802.3ae (10GBASE Ethernet)
- IEEE802.3az (Energy Efficient Ethernet)
-
IEEE 802.3x (Full-duplex flow control)
- IEEE 802.1af (PoE)
- IEEE 802.1at (PoE+)
• AutoSensing and autonegotiating capabilities for all ports.
• Auto Uplink™ technology is supported on all ports.
• Automatic address learning function to build the packet-forwarding information
table. The table contains up to 16K Media Access Control (MAC) addresses.
Introduction 9 Hardware Installation Guide