Back Panel, 4300 Series 1G Models With 10G Uplinks - NETGEAR M4300 Intelligent Edge Series Hardware Installation Manual

M4300 Intelligent Edge Series Fully Managed Stackable Switches
• Two dedicated 10GBASE-X SFP+ ports, each with a combined speed and activity
LED (see LEDs, M4300 series 1G models with 10G uplinks on page 29):
- On model M4300-28 and model M4300-28G-POE+, these are port numbers 27
and 28.
- On model M4300-52G and model M4300-52G-POE+, these are port numbers
51 and 52.
• One out-of-band (OOB) 1G Ethernet port with a left LED that indicates the speed
and a right LED that indicates the activity (see LEDs, M4300 series 1G models with
10G uplinks on page 29).
• One USB 2.0 port.

Back panel, 4300 series 1G models with 10G uplinks

Models M4300-28G, M4300-28G-POE+, and M4300-52G
The following figure illustrates the back panel of full-width models M4300-28G,
M4300-28G-POE+, and M4300-52G.
Figure 13. Back panel models M4300-28G, M4300-28G-POE+, and M4300-52G
Number
1
2
3
From left to right, the back panel of models M4300-28G, M4300-28G-POE+, and
M4300-52G provides the following components:
• One RJ-45 RS232 (115200, N, 8, 1) console port.
• Fixed fans for front-to-back air flow.
• Modular bay in which for model M4300-28G and model M4300-52G an APS150W
power supply unit (PSU) is installed. For model M4300-28G-POE+, an APS550W
PSU or APS1000W PSU is installed, depending on the product ordered.
• Second modular bay for an optional second PSU.
Hardware Overview
Description
RJ-45 RS232 console port
PSU1 with AC connector
Bay for PSU2
27 Hardware Installation Guide