NETGEAR M4300 Intelligent Edge Series Hardware Installation Manual page 50

M4300 Intelligent Edge Series Fully Managed Stackable Switches
Figure 24. Switch package contents, full-width models
Check the contents of the boxes to make sure that all items are present before installing
the switch. If any item is missing or damaged, contact your local NETGEAR reseller for
replacement.
To check the package contents:
1. Place the container on a clean flat surface, and cut all straps securing the container.
2. Unpack the hardware from the boxes by carefully removing the hardware and placing
it on a secure and clean surface.
3. Remove all packing material.
4. Verify that the package contains the following items:
• Switch of the correct model.
• Power cord.
• Console cable with one DB9 connector and one RJ-45 connector.
• USB console cable with one mini B connector and one type A connector.
• Rack-mounting kit:
- The half-width models include a long bracket, regular (short) bracket, and
screws. The kit also includes two inside and two outside middle mounts, which
allow you to install two half-width switches in a single rack space.
- The full-width models include two regular (short) brackets and screws.
• Rubber footpads for tabletop installation.
• Quick installation guide.
Installation 50 Hardware Installation Guide