Input Terminal 9 (Li1) Function; Input Terminal 10 (Li2) Function; Input Terminal 11 (Li3) Function - Toshiba H9 Installation And Operation Manual

F119

Input Terminal 9 (LI1) Function

Program ⇒ Terminal ⇒ Input Terminals
This parameter is used to set the functionality of the LI1 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI1 terminal to any one
of the user-selectable functions listed in
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
more information on the function of this terminal.

Input Terminal 10 (LI2) Function

Program ⇒ Terminal ⇒ Input Terminals
This parameter is used to set the functionality of the LI2 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI2 terminal to any one
of the user-selectable functions listed in
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
more information on the function of this terminal.

Input Terminal 11 (LI3) Function

Program ⇒ Terminal ⇒ Input Terminals
This parameter is used to set the functionality of the LI3 discrete input terminal.
In addition, this input terminal must be specified as Normally Open or
Normally Closed.
This setting assigns the function of the programmable LI3 terminal to any one
of the user-selectable functions listed in
Note: The Expansion IO Card Option 1 option board (P/N ETB003Z)
is required to use this terminal.
See the Expansion IO Card Option 1 instruction manual (P/N 58685) for
more information on the function of this terminal.
90
Table 5 on pg. 236.
Table 5 on pg. 236.
Table 5 on pg. 236.
Direct Access Number — F119
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F120
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Direct Access Number — F121
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
H9 ASD Installation and Operation Manual
F121