Lcd Display - Toshiba H9 Installation And Operation Manual

LCD Display

The LCD Display is the primary user input/output information center. Parameter settings may be viewed
or changed using the LCD display module of the EOI. To view or change a parameter setting using the
LCD display, press the Mode key until the Program menu is displayed. Turn the Rotary Encoder until
the desired Primary Menu item is within the cursor block. Press the Rotary Encoder to select the item
from the Primary Menu (repeat the press-to-select for submenu items).
See the section titled
settings.
Upon reaching the desired parameter selection the current setting may be viewed, or it may be changed by
pressing the Rotary Encoder and the setting will take on the reverse video format (dark background/light
text). Turn the Rotary Encoder to change the parameter setting. Press the ESC key while the new
parameter setting is in the reverse video mode to exit the selection without saving the change or press the
Rotary Encoder while the parameter setting is in the reverse video mode to accept the new setting.
Repeated ESC key entries at any time takes the menu back one level each time the ESC key is pressed
until the Frequency Command screen is reached. Further ESC entries will toggle the system to and from
the Frequency Command screen and the EOI Command menu.
Note: Changes carried out from the EOI Command screen will be effective for EOI-
controlled ASD operation only. See the section titled
further information on
Primary Menus of the LCD Display
The three Primary screens of the LCD display are displayed while accessing the associated operating
mode: the Frequency Command, Monitor, and the Program Menu screens.
Figure 22. Frequency Command Screen Items.
Speed Reference %
Speed Reference Hz
User-selected
Monitored Parameters (see
Main Monitor Selections on pg.
Discrete I/O terminal status or
alarm condition
Figure 23. Monitor Screen Items (see
Screen Name
Active Frequency Active Frequency
Command
Active DC Bus Voltage
Figure 24. Program Menu Items (see
Screen Name
Primary Menu Items
H9 ASD Installation and Operation Manual
Default Setting Changes on pg. 74
EOI Command Mode
S h o w s d i s c r e t e I / O t e r m i n a
45)
pg. 43
pg. 46
Program
Startup Wizard...
{
Fundamental...
Terminal...
Direct Access...
Utilities...
for more information on changing parameter
EOI Command Mode on pg. 42
operations.
l s t a t u s w h e n n o t i n a l a r m m o d e .
for more on the Monitor Screen items).
for more on the Program Menu Screen).
01:15
for
Not-Ready-to-Run
Indicator (ST-to-CC required)
Ready-to-Run Indicator
appears when ST is connected
to CC
Forward Run Active
Reverse Run Active
Item Number 1 of 43
Monitored items
(only 5 items listed)
Speed at Trip (if applicable)
Active output Current
ASD Output Voltage
Item Number 1 of 15
Program Menu items
(only 5 items listed)
31