Cable/Terminal/Torque Specifications - Toshiba H9 Installation And Operation Manual

Cable/Terminal/Torque Specifications

Installation should conform to the 2005 National Electrical Code Article 110 (NEC
Installations), all regulations of the Occupational Safety and Health Administration, and any other
applicable national, regional, or industry codes and standards.
Note: The following ratings are guidelines and shall not be the sole determining factor of the
lug or wire size used with the H9 ASD. Application-specific applicables, wire insulation
type, conductor material, and local and regional regulations are but a few of the
considerations when selecting the actual lug and wire type to be used with the H9 ASD.
Note: Cable/Terminal specifications are based on the rated current of the H9 ASD and Do
Not include the 10% Service Factor.
Note: Use only 75° C copper wire/cable for motor and power connections.
For further installation information see the section titled
Model
MCP Rating
Number
(Amps)
VT130H9U
2035 30
2055 30
2080 50
2110 50
2160 75
2220 100
2270 125
2330 150
2400 175
2500 200
2600 250
2750 300
210K 400
212K 500
Note: (*) Indicates that the item is one of a set of two parallel cables.
H9 ASD Installation and Operation Manual
Table 20. 230-Volt H9 ASD Cable/Terminal/Torque Specifications.
Wire/Cable Size
Input/Output Power
Recommended Maximum
14 10
10 10
8 8
8 8
6 3
4 3
3 3
2 2
1/0 4/0
2/0 4/0
3/0 4/0
4/0 4/0
*3/0 *1/0
*250 *250
Installation and Connections on pg.
Lug Size Range
AWG or kcmil
Wire-Size/Lug-Capacity for
Input/Output Power
3Ø-Input 3Ø-Output
14 to 8
12 to 8
8 to 3
12 to 1/0 4 to 1/0
6 to 250 2 to 300
6 to 250
) (Requirements for Electrical
14.
Terminal
Board
Torque
TB1 – 4
3Ø-Input 3Ø-Output
Terminals
In-Lbs./Nm
11.5/1.3
17.7/2.0
21/2.4
20
(3-core shield)
50/5.7
5.3/0.6
275/31
275/31
53/6
168/19
265