Toshiba H9 Installation And Operation Manual page 140

F288
Preset Speed 9
Program ⇒ Frequency ⇒ Preset Speeds
This parameter assigns an output frequency to binary number 1001 and is
identified as Preset Speed #9. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see
this parameter).
Preset Speed 10
Program ⇒ Frequency ⇒ Preset Speeds
This parameter assigns an output frequency to binary number 1010 and is
identified as Preset Speed #10. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see
this parameter).
Preset Speed 11
Program ⇒ Frequency ⇒ Preset Speeds
This parameter assigns an output frequency to binary number 1011 and is
identified as Preset Speed #11. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see
this parameter).
Preset Speed 12
Program ⇒ Frequency ⇒ Preset Speeds
This parameter assigns an output frequency to binary number 1100 and is
identified as Preset Speed #12. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see
this parameter).
Preset Speed 13
Program ⇒ Frequency ⇒ Preset Speeds
This parameter assigns an output frequency to binary number 1101 and is
identified as Preset Speed #13. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see
this parameter).
Preset Speed 14
Program ⇒ Frequency ⇒ Preset Speeds
This parameter assigns an output frequency to binary number 1110 and is
identified as Preset Speed #14. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see
this parameter).
132
F018 for more information on
F018 for more information on
F018 for more information on
F018 for more information on
F018 for more information on
F018 for more information on
Direct Access Number — F288
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Direct Access Number — F289
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Direct Access Number — F290
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Direct Access Number — F291
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Direct Access Number — F292
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Direct Access Number — F293
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
H9 ASD Installation and Operation Manual
F293