Frymaster H55 Series Technical Reference Manual page 102

Show location of thermal reset on Filter Motor
Have filter prompts been added or demonstrated?
TROUBLESHOOTING
Common error messages
Is Vat Full? – a problem may exist in the filtration system – Follow instructions on the controller to
ensure any or all oil is returned from the filter pan.
Drain Clogged- Clear Drain-Is Drain Clear? (Gas Only) – Follow instructions on the controller using
the new fryers friend to clear the drain.
Filter Busy – a filtration process is in another vat
Probe Failure – Temperature circuitry has a problem – Turn off fryer and call for service
Heating Failure – Unit is not heating – Turn off fryer and turn on again.
Low Temp – Oil temperature below set point – may occur during cooking cycle
Recovery Fault – Vat did not meet minimum specs for temperature recovery – Press the YES button
to continue.
Service Required – a problem exists that requires a technician.
Frymaster's Hot line and FAS contact person / with phone numbers
FILTRATION PERSON(S) / MANAGERS
Refer to Refer to the FilterQuick
Demonstrate daily cleaning of the oil sensor during Clean and Filter with no-scratch pad (gas only).
FILTER MENU (Press and hold FILTER button)
NON BULK OIL SYSTEM
Demonstrate how to access FILTER MENU
Show FILTER and explain what it does
Show CLEAN and FILTER (clean oil sensor on gas units)
Show DISPOSE and explain what it does (Use of SDU)
Show DRAIN TO PAN and explain what it does
Show BOIL OUT and explain what it does
Show FILL VAT FROM PAN and explain what it does
BULK OIL SYSTEM
Demonstrate how to access FILTER MENU
Show FILTER and explain what it does
Show CLEAN and FILTER (clean oil sensor on gas units)
Show DISPOSE and explain what it does
Show DRAIN TO PAN and explain what it does
Show BOIL OUT and explain what it does
Show PAN TO WASTE and explain what it does
Show FILL VAT FROM PAN and explain what it does
Show FILL VAT FROM BULK and explain what it does
Refer to Refer to the FilterQuick
Demonstrate how to access MAIN MENU PROGRAMMING – (Press and hold CHECK) Code 1650
Demonstrate Product Setup and setting up an item and Assigning Buttons
Demonstrate how to add a new Menu Item – setup a test menu item (short cook cycle)
Demonstrate placement and use of the menu strip
Demonstrate how to access INFO MODE (Press and hold INFO for three seconds)
Automatic Filtering Fryers
™
Quick Start Guide and the FilterQuick
STORE MANAGERS ONLY (OR DESIGNATED PERSONS)
™
Quick Start Guide and the FilterQuick
Page 3 of 4
4-58
™
Controller Manual Chapter 1
™
Controller Manual Chapter 1