Lexus ES 250 Owner's Manual page 68

This seat is fitted with a Top tether
anchorage point.
Never use a rear-facing child
restraint system on the front pas-
senger seat.
*1
: Move the front seat fully rearward. If the
passenger seat height can be adjusted,
move it to the upper most position.
*2
: Adjust the seatback angle to the most
upright position. When installing a for-
ward-facing child seat, if there is a gap
between the child seat and the seat-
back, adjust the seatback angle until
good contact is achieved.
Detail information for CRS installation
■
Seat position number
Seating position suitable for
universal belted (yes/no)
i-Size seating position (yes/no)
Seating position suitable for
lateral fixture (L1/L2/no)
Suitable rearward facing fix-
ture (R1/R2X/R2/R3/no)
Suitable forward facing fixture
(F2X/F2/F3/no)
Suitable junior seat fixture
(B2/B3/no)
ISOFIX child restraint systems are divided into different "fixture". The child
restraint system can be used in the seating positions for "fixture" mentioned in the
table above. For kind of "fixture", confirm the following table.
If your child restraint system has no kind of "fixture" (or if you cannot find informa-
*3
: If the head restraint interferes with your
child restraint system, and the head
restraint can be removed, remove the
head restraint.
Otherwise, put the head restraint in the
upper most position.
*4
: Use only a front-facing child restraint
system.
Seating position
yes
yes
Forward-fac-
ing
no yes
no no
R1, R2X, R2,
no
R3
no F2X, F2, F3
no B2, B3
67
1-2. Child safety
yes yes
no yes
no no
R1, R2X, R2,
no
R3
no F2X, F2, F3
no B2, B3
1