Lexus ES 250 Owner's Manual page 244

Fine adjustment: Press the switch.
Large adjustment: Press and hold the
switch to change the speed, and release
when the desired speed is reached.
In the vehicle-to-vehicle distance con-
trol mode, the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*2
or 1 mph (1.6 km/h) each time the
switch is pressed
Large adjustment: Increases or
decreases in 5 km/h (3.1 mph)
*2
mph (8 km/h) increments for as long
as the switch is held
In the constant speed control mode
(P.245), the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*2
mph (1.6 km/h) each time the switch is
pressed
Large adjustment: The speed will continue
to change while the switch is held.
*1
: When the set speed is shown in "km/h"
*2
: When the set speed is shown in "MPH"
Changing the vehicle-to-vehicle
distance (vehicle-to-vehicle dis-
tance control mode)
Pressing the switch changes the vehi-
cle-to-vehicle distance as follows:
4-5. Using the driving support systems
*1
1
Long
2
Medium
3
Short
*1
The vehicle-to-vehicle distance is set auto-
or 5
matically to long mode when the engine
switch is turned to IGNITION ON mode.
If a vehicle is running ahead of you, the pre-
ceding vehicle mark
played.
*1
Vehicle-to-vehicle distance set-
or 1
tings (vehicle-to-vehicle dis-
tance control mode)
Select a distance from the table below.
Note that the distances shown corre-
spond to a vehicle speed of 80 km/h
(50 mph). Vehicle-to-vehicle distance
increases/decreases in accordance
with vehicle speed. When the vehicle is
stopped by system control, the vehicle
stops at a certain vehicle-to-vehicle
distance depending on the situation.
Distance options
Long
243
A
will also be dis-
Vehicle-to-vehicle
distance
Approximately 50
m (160 ft.)
4