Lexus ES 250 Owner's Manual page 294

Time
C
Engine output restriction control begins operating
D
System determines that possibility of collision with detected object is high
E
Engine output reduced
F
System determines that possibility of collision with detected object is extremely
G
high
Brake control begins operating
H
Brake control strength increased
I
Example: Multi-information display: "BRAKE!"
J
Example: Multi-information display: "Switch to Brake"
K
■ If the Parking Support Brake has oper-
ated
If the vehicle is stopped due to operation of
the Parking Support Brake, the Parking
Support Brake will be disabled and the
PKSB OFF indicator will illuminate. If the
Parking Support Brake operates unneces-
sarily, brake control can be canceled by
depressing the brake pedal or waiting for
approximately 2 seconds for it to automati-
cally be canceled. Then, the vehicle can be
operated by depressing the accelerator
pedal.
■ Re-enabling the Parking Support Brake
To re-enable the Parking Support Brake
when it has been disabled due to system
operation, perform any of the following
operations. At this time, the PKSB OFF indi-
cator will turn off. (P.100)
● Turn the PKSB system on (P.289)
● Turn the engine switch off, and then back
to IGNITION ON mode
Shift the shift lever to P
●
● Drive with no operation targets in the
traveling direction of the vehicle
● Change the traveling direction of the
vehicle
4-5. Using the driving support systems
If "Parking Support Brake Unavailable"
■
is displayed on the multi-information
display and the PKSB OFF indicator is
flashing
If this message is displayed only when the
●
shift lever is in R, the rear camera lens
may be dirty. Clean the camera lens. If
this message is displayed when the shift
lever is in any position other than R, a sen-
sor on the front or rear bumper may be
dirty. Clean the sensors and their sur-
rounding area on the bumpers.
● Initialization may not have been per-
formed after a battery terminal was dis-
connected and reconnected. Initialize the
system. (P.294)
If this message continues to be displayed
even after initialization, have the vehicle
inspected by your Lexus dealer.
If "Parking Support Brake Unavailable"
■
and "Parking Assist Unavailable Clean
Parking Assist Sensor" are displayed on
the multi-information display and the
PKSB OFF indicator is flashing
● A sensor may be covered with ice, snow,
dirt, etc. In this case, remove the ice,
snow, dirt, etc., from the sensor to return
the system to normal. If this message is
shown even after removing dirt from the
sensor, or shown when the sensor was
not dirty to begin with, have the vehicle
inspected at your Lexus dealer.
293
4