Lexus ES 250 Owner's Manual page 420

 Tail lights
 Stop lights
 Rear turn signal lights
 Back-up lights
 High mounted stoplight
 License plate lights
 Rear fog lights (if equipped)
■ LED lights
The lights other than the front turn signal
lights (vehicles with single-beam head-
lights) each consist of a number of LEDs. If
any of the LEDs burn out, take your vehicle
to your Lexus dealer to have the light
replaced.
■ Condensation build-up on the inside of
the lens
Temporary condensation build-up on the
inside of the headlight lens does not indi-
cate a malfunction. Contact your Lexus
dealer for more information in the following
situations:
Large drops of water have built up on the
●
inside of the lens.
● Water has built up inside the headlight.
When replacing light bulbs
■
P.418
Replacing light bulb
Front turn signal lights (vehicles
■
with single-beam headlights)
1
To ensure enough space to per-
form work, turn the steering wheel
to rotate the front wheel away from
the bulb to be replaced. Remove
the fender liner clip.
Turn the steering wheel to the left when
replacing the right side light bulb, and turn
the steering wheel to the right when
6-3. Do-it-yourself maintenance
replacing the left side light bulb.
2
To protect the front bumper from
being damaged, apply protective
tape around the clips as shown in
the illustration.
Use masking tape, etc. Do not use duct
tape, as it may leave residue or damage the
paint when removed.
3
Insert a flathead screwdriver
between the front bumper and
fender liner and then separate the
front bumper from the fender liner.
To separate the front bumper from the
fender liner, pry up the fender liner while
419
6